For the House and Cottages

Simple drinker-polivalka for any occasion

Pin
Send
Share
Send
Send


Extremely simple, not requiring special care drinker-sprinkler can be made in minutes from scrap materials. All you need is an empty plastic bottle and a pair of cocktail tubes. In this case, the result is beyond all praise. The design can be used for watering indoor plants, it is suitable for the construction of drinking bowls. The special charm is that there is nothing to break.

Features of production and the principle of the miracle drinkers

Choose a plastic bottle of the right size.

We make in it 2 holes, sufficient to ensure that they included cocktail tubes.

Insert the tubes into the holes from the side of the bend.

We seal the holes with a glue gun, and then we trim the tubes. The submerged part of the lower tube should be about 2 cm shorter than the upper one.

Fill the bottle, slightly topping up, and tightly twist. We turn over upside down, we are convinced that water flows freely into the tubules.

We turn over the bottle, substituting the necessary container under the tubes and wait until the water covers both tubes. At that moment, when both tubes are covered with water, the filling of the additional tank will stop. Water supply will be dosed. As the water in the additional tank is consumed, air bubbles will enter the bottle, replacing the gradually flowing liquid.

If desired, it is easy to provide flowers with continuous watering or dosed top dressing. This may be particularly relevant during the holidays.

More about the features of the assembly in the video:

Pin
Send
Share
Send
Send